Insert the new bolt into the opening on the edge of the door and fasten it to the door with the provided screws.
Replace door handle with deadbolt.
More product details close brandywine stainless steel keyed entry knob and single cylinder deadbolt combo pack.
Compare both locks to verify that they re the same size before proceeding.
Backset measured from the door edge to the center of the dead bolt hole then install it in the deadbolt hole.
How to replace a front door lock with a keyed deadbolt 1.
There s really less security you would get even with a deadbolt lock.
Insert the exterior part of the lock into the door by feeding the long metal piece through the opening in the center of.
Open the door and examine the edge.
Remove the handle from the interior of the door by pressing a flathead screwdriver into the side of the handle.
If you have a hollow core door there is no reason to replace a deadbolt lock with another deadbolt.
How to install the door lock.
I had to fix it.
Set the new dead bolt to match the existing 2 3 8 in.
The door will be so insecure that the lock matters very little.
If the deadbolt comes with an interior plate and a decorative.
And the owners of a hollow core door you simply need to think about your door.
It would be better to go with a locking door handle when you replace a deadbolt on an insecure interior door.
Here is the handleset i bought.
Position the door so.
Removing faceplates from old lock.
Are you adding a new lock to the door.
The security up gradation also needs a locking door handle.
Here s how i did it.
To remove the handleset use the flat head screw driver to pry off the screw cover.
My front door knob was broken and i couldn t open the door from the inside or outside.
Remove the door knob by removing the screws from the door knob.
The wrong type of deadbolt will never be enough to hold those criminals out of your space.
Open the front door lock so that it s not engaged in the locked position and open the door.
A difference in sizes will require the use.
The sloped side of the latch should face in the same.